Roofing FAQ's
- Who is Scott's Exteriors?
- How do I receive appointments?
- Why should I choose Scott's Exteriors?
- How long does it take to replace a roof?
- Can I replace missing and damaged tiles or shingles without calling Scott?
- What is an ice dam?
Who is Scott's Exteriors?
When you need a new roof, Scott's Exteriors is there, working to simplify the process. Whether looking for information about roofing materials or searching for a reliable contractor, we take the hassle out of your roofing experience. From new construction to re-roofing or repair, no roofing job is too big or difficult for Scott's Exteriors. Our workers are certified and experienced, utilizing a full line of roofing materials. All the information you need is just a mouse click away.
back to top
How do I receive appointments?
Scott's Exteriors alerts you to appointments by phone.
back to top
Why should I choose Scott's Exteriors?
There are many reasons why Scott's Exteriors is the right choice for you.
- Time savings – You are saved time and hassle when Scott's Exteriors sets your appointment. Yes, that’s right, you will not ever have to search through the phone book for a roofing contractor again!
- Provides confidence - Our employees are reliable and qualified. No more need to worry that the contractor you picked from the phone book will cheat you or use inferior materials.
- Online education – Our site offers free advice, information, and assistance.
back to top
How long does it take to replace a roof?
Replacing a roof, whether on a commercial or residential building, is a labor-intensive project and, depending on the type of roof, could take anywhere from a few days to 2 or more weeks. The time involved is substantially affected by the weather, as well. Wind, snow, rain, or even just the threat of one of these and will slow the process considerably.
For built-up roofs, removing and replacing the roof will probably proceed at a rate of approximately 1,500 square feet per day. For single-ply roofs, the rate is closer to 2,000 to 4,000 square feet per day. Careful planning and close project management can reduce some of the delays caused by bad weather.
back to top
Can I replace missing and damaged tiles or shingles without calling a roofing contractor?
It is always recommended that you use a professional, but in case of an emergency, it is possible for you to replace the shingle or broken tile yourself.
Composition shingles:
For composition shingles, roofing cement can be used to repair torn
or curled shingles. Stabilize repaired shingles with nails or a heavy board
until the cement has dried.
To replace a composition, carefully lift the shingle above the missing shingle, then trim and place the new shingle underneath so that it doesn't catch on any edges (it may be necessary to remove excess staples or nails). Carefully nail the new shingle into place.
Wood shingles or shakes:
For wood shingles, repairs are best done with an aluminum piece that
can be slid under the shingle. This should protect the exposed area, while
not being visible from below.
To replace a wood shingle requires a special tool, a shingle ripper, to slip under the shingle and hook and cut the nail. The nail can also be cut with a hacksaw, but is difficult to do. Slip the new shingle into position, but leave it ¼ inch longer than the other shingles. Then nail it into place right below the end of the overlapping shingle above. Finally, with a block of wood against the shingle butt, drive it up the last ¼ inch to bend the nails under the shingle above.
Tiles:
To replace a tile, remove all of the broken pieces, then gently lift the
tiles and slide the new tile into place until it hooks over the batten.
back to top
What is an ice dam?
Ice dams occur when snow melts near the ridgelines of warm roofs (roofs without adequate ventilation). As the water runs down the roof to the overhang, it cools and freezes. If the snow continues this melt and freeze process, an ice dam can form that can seep under the shingles, through the decking and into the house. This, of course, can cause serious roof leaks--even in freezing temperatures.
The best prevention to ice dams is a well-ventilated (cool) roof. Additional protection for your roof can be applied with an impermeable ice and water membrane. The membrane is installed on top of the decking, under the roofing material.
Temporary prevention of ice dams can also be done through the use of electric cables along the eaves of the roof (where the dams usually form). However, new ice dams can form above the cables and still cause extensive damage. Another emergency solution to ice dams is to fill a sock or nylon with calcium chloride. Lay the stocking vertically across the ice dam. The calcium chloride will melt the ice and release the water so that it can drain outside, and not inside your roof.
back to top
Fill out one of our free estimate forms (free roofing quote and free siding quote) or contact us to start Scott's Exteriors working for you.
Scott's Exteriors will quickly
begin scheduling your appointment at the times of your choice.